Connecting To An Inside Antenna Setup; Connecting To An Outdoor Antenna Setup - jWIN JV-DTV17 Manual Del Usuario

Connecting to an Inside Antenna Setup

- Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below. - Typical wall antenna jack used in apartment buildings, connect the antenna cable as shown below.
- If you have a 75Ω round cable, insert the bronze wire and then tighten the connection nut. If you have a 300Ω flat wire, con-
nect the twisted wire to the antenna converter and then connect the converter to the antenna jack on the TV.
- If using 75Ω round cable, do not bend the bronze wire. It may cause poor picture quality.

Connecting to an Outdoor Antenna Setup

- This type of antenna is commonly used in single family dwellings.
10
(Use the correct type of antenna cable for the type of wall antenna jack.) (Use the correct type of antenna cable for the type of wall antenna jack.)
Apartment Buildings Wall Connection Jack
VHF Antenna
UHF
Antenna
Single Family Home
- In poor signal areas, to get better picture quality,
install a signal amplifier to the antenna as shown to
the right.
- If signal needs to be split for two TVs, use an
antenna signal splitter for connection.
Turn clockwise to tighten.
Bronze Wire
75Ω Round Cable
Antenna
Converter
300Ω Flat Wire
Turn clockwise to tighten.
75Ω Round Cable
Bronze Wire
300Ω Flat Wire
Antenna Converter
VHF
UHF
Signal
Amplifier
ANT ANT. IN . IN AC INPUT AC INPUT
Antenna Jack
AC INPUT AC INPUT
ANT. IN ANT . IN
Antenna Jack
ANT. IN ANT . IN AC INPUT AC INPUT