Linet Roller Bars for Tom 2 Manual Del Usuario página 7

Fig. Fixed protector rollers on the upper corner of the bed
Fig. Removal of protector rollers
D9U001KRB-01ML_01
The protector may be removed as fo-
llows:
1) Unscrew a safety screw on the
one upper corner of the bed (position 1
on the picture).
2) Remove longer roller from the
bushing on this upper corner of the bed
(position 2 on the picture).
3) Raise this longer roller on this
upper corner of the bed carefully and
remove pin of the shorter roller from the
bushing of this longer roller (position 3
on the picture).
4) Hold the shorter roller released
at one end and insert pin of the longer ro-
ller into the bushing on this upper corner
of the bed again.
5) Remove pin of the shorter roller
on the opposite side from the bushing in
order to remove the shorter roller from
the assembled protector.
6) Go to the opposite bed end and
release the second shorter roller accor-
ding to instructions in points 1) to 5).
7) Remove the protector longer ro-
llers from bushings on the upper corners
of the bed.
8) Screw each of 4 safety screws on
the upper corners of the bed.
9) Ensure that each of 4 safety
screws on the upper corners of the bed is
tightened.
Use an allen key (size 5 mm) to tighten
screws with torque 5+2 Nm.
10) Store all four protector rollers
safely.
7