Bissell REVOLUTION PET PRO 1986 Serie Guía De Inicio Rápido/Del Usuario página 19

Cleaning Machine After Use
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
First, fill the clean water
tank with warm tap water
and then empty it all to
rinse. Then fill again with
warm tap water and return
the tank to the machine.
Twist cap back on tightly.
Brush Roll & Nozzle Care
NOTE: Be sure to clean the brush rolls and nozzle before storing your machine.
Follow these steps if your nozzle becomes clogged with hair or debris.
1
3
NOTICE: To reduce the risk of a leaking condition, do not store unit where
freezing may occur. Damage to internal components may result.
To flush and rinse the
machine: Turn the machine
on and press the trigger for
15 seconds while making
back and forth passes on a
section of carpet.
Finally, release the trigger
and extract the water.
Turn off and unplug
the machine from the
grounded outlet.
Next, remove
the next layer,
the brush roll
cover, to reveal
the brush rolls.
Press on the
two release
buttons and lift
straight up.
See page 16 to clean the
dirty tank from the water
that was just extracted.
Empty the clean water tank
and let dry before storing.
Wipe your machine's
exterior with a soft cloth.
Store machine in a
protected dry area.
2
4
Remove the nozzle
from the foot:
scoop and grip the
Accessory Hose
Door. Pull up to
remove the nozzle.
At this point, the
nozzle and brush
roll cover can
be rinsed under
running water and
the nozzle clean
out tool can be
inserted to unclog
hair or debris.
www.BISSELL.com
17