Tabla de contenido
Publicidad
Technical Information
Technical Information
Technical Specifications
EX-1280
Integrated DSP
Signal Processor
Maximum Calculation
Delay
Audio Latency
A/D & D/A Converters
Sample Rate
Analog Audio Inputs
Input Channels
Input Connectors
Input Impedance
Maximum Input Level
Equivalent Input Noise
Phantom Power
Gain Settings
Analog Audio Outputs
Output Channels
Output Connectors
Output Impedance
Maximum Output Level
Audio Performance
Frequency Response
THD+N
Channel Separation (Crosstalk)
Dynamic Range
Audio Over IP
Dante
Digital Audio Outputs
AmpLink (output only)
Communication Ports
USB Device
USB Host
28 • English
32-bit fixed/floating-point DSP 456 MHz/Arm Cortex-A8 600 MHz
3.6 GIPS / 2.7 GFLOPS
43 s
1.05 ms (analog in to analog out)
24-bit
48 kHz
12 balanced, mic/line level
3.81 mm, 6-pin Euroblock
12 kΩ at 1 kHz (with or without phantom power active)
+24 dBu
−118 dB at 44 dB gain setting
+48 VDC, 10 mA, selectable per input
0/+14/+24/+32/+44/+54/+64 dB
8 balanced, line-level
3.81 mm, 6-pin Euroblock
200 Ω
+24 dBu
20 Hz to 20 kHz (+0.5 dB/−0.5 dB)
0.01% at +4 dBu (A-weighted, 20 Hz to 20 kHz)
< −105 dB at +4 dBu input & output level, 1 kHz
> 115 dB, A-weighted, 20 Hz to 20 kHz, analog input to analog output
64 × 64, primary/secondary
8 ultra-low latency (< 21 μs), 48 kHz; requires shielded Cat 5 cable
Micro-B type, stereo in/out, HID support
Type A; for future use
EX-440C/1280/1280C/12AEC • Installation & Operation Guide
PRO.BOSE.COM
Publicidad
Tabla de contenido
