Installation And Connection; Operating - Bartscher 109.470 Mantenga Las Instrucciones

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
Never leave the unit near flammable substances or gases.
•
Never leave the unit in a wet or dirty place.
•
Ensure that the unit does not come into contact with any conductive materials.
•
Ensure that the hot air exhaust does not come into contact with any liquids
(especially water), as this may damage the heater or resistor.
•
Ensure that the unit's operator has sufficient space to work.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operating

CAUTION!
The unit should be operated only by qualified personnel!
•
Prior to first use, wash by hand the polishing head cloths in warm water with a neutral
cleaning agent. Rinse them thoroughly in clean water and dry at room temperature.
Installing the polishing head cloths
•
Place the polishing head cloths on the heads. Remember to place the interior glass
polishing head cloth on the middle head, and the larger ones place on any of the
remaining 4 heads.
- 25 -