Cub Cadet RT 35 Manual Del Operador página 8

Attaching the Cable
To attach the cables, follow these steps:
1. Route the cable along the handle assembly on the right-
hand side. See Figure 3-2.
2. Connect the forward drive cable to the clutch bail by
feeding the z-hook through the hole on the clutch bail
from the outside towards the inside. See Figure 3-2.
3. Snap the cable housing clips into the handle assembly
cable mount as shown in Figure 3-2. The clip feeds into the
lower position on the handle assembly. See Figure 3-2.
NOTE: To test the function of the clutch bail, lift the bail
to the handle and release it. The bail should return to its
neutral position. If it doesn't, contact your local dealer for
technical assistance.
8 S 3 — A
ection SSembly
Forward
Drive Cable
Cable Mount
Clutch Bail
Figure 3-2
& S -U
et p
4. Clip the cable into the cable guide located on the handle
assembly panel as seen in Figure 3-3.
Figure 3-3
Move Tiller Off Crate
To roll the tiller off the shipping platform, put the wheels in
freewheel, if they are not already from the factory, as follows:
1. Place a sturdy block under the transmission to raise one
wheel about 1" off the ground. Remove the click pin from
the wheel hub and wheel shaft. See Figure 3-4.
Click Pin
Remove the click pin
from the wheel hub
Figure 3-4
2. Slide the wheel fully inward on the wheel shaft . Reinstall
the click pin through the wheel shaft only (not through the
wheel hub). See Figure 3-4. The wheel should now spin freely
(freewheel) on the wheel shaft. Repeat with the other wheel.
3. Use the handlebar to roll the tiller to a flat area.
NOTE: Before starting the engine, the wheels must be
placed in the WHEEL DRIVE position (pins through wheel
hubs and wheel shaft).
4. Once the tiller is off the crate, place the wheels in the
WHEEL DRIVE position, remove the click pin, slide the
wheel fully inward and reinstall the click pin.
Slide the wheel fully
inward on the wheel
shaft . Reinstall the
click pin