Getting To Know The Xtc-300; Battery; Micro Sd Card; Battery Status Indicator - Midland XTC300 Guía Rápida De Inicio

Getting to Know the XTC-300

Battery

1. To insert the battery, push down the battery door latch on the back of
the camera.
2. Pull battery door backwards to open.
3. Install Lithium-Ion battery, observing proper direction.
4. Return battery door and click into place.
Battery Status
Indicator
Solid Green
Blinking Green
Solid Orange
Solid Red
Blinking Red*
No Light
*Note: When the red battery LED begins blinking, be prepared
to charge the battery because the camera will stop recording
at this point.

Micro SD Card

1. Lift latch on back to open the door
2. Insert Micro SD card into slot observing proper direction (shown below).
3. Close door until it clicks shut
Meaning
Indicates full battery life
Battery is charging
Medium battery life
Indicates low battery life
Too low to operate
Batteries are depleted.
www.midxtc.com
Getting to Know the XTC-300

Recording

1. Move the RECORD switch forward. This turns the camera on.
2. The battery indicator will light from red to green. The SD card
indicator will illuminate. The camera is capturing audio and video when
the REC indicator is flashing.
3. To stop recording, move the RECORD switch back to the off position.
SD card LED
Status
Green
Orange
Red
Flashing Red
Indicates card is being
Flashing Green
1080p Record
Memory Size
Time
512 MB 7.5 Minutes
1 GB 15 Minutes
2 GB 30 Minutes
4 GB 60 Minutes
8 GB 120 Minutes
16 GB 240 Minutes
32 GB 480 Minutes
Note:
1. The camera automatically splits the video into 2 GB segments.
2. HD video requires class 4 micro SD card to record and
playback
Meaning
75% more available.
34% - 75% available.
Less than 34%
or no Micro SD
card installed.
Cannot read the card.
reformatted.
720p Record 480p Record
Time Time
6.5 Minutes 10 Minutes
13 Minutes 20 Minutes
26 Minutes 40 Minutes
52 Minutes 80 Minutes
104 Minutes 160 Minutes
208 Minutes 360 Minutes
416 Minutes 720 Minutes
3