Regulation (Digital Display) - Polytropic PAC 16 Manual De Instrucciones

Polytropic
You can then start your machine. (Follow every point in the below order each
time you start the pool heat pump, especially at the beginning of a season):
• Open by-pass valves
• Start pool system pump
• Turn on pool heat pump with on/off switch (turn it to « I »).
Pool heat pump will work after a time delay (about 2 minutes).
• Set regulation (Chapter «Regulation»).
• Set heating (Chapter «Heating»).
After a few minutes (time for circuit to heat itself) you can regulate water flow as
explained hereafter (Chapter "Water flow regulation")

Regulation (digital display)

Water set point temperature setting:
1. Press and hold
press
After a moment, the previously value begins to flash.
2. Increase or decrease the set point value with the
the desired value is displayed.
3. Press
The recommended heating temperature is 28° C, higher temperatures are
not recommended.
These units are designed to operate in ambient air temperatures between 8° C
and 35° C.
When compressor is stopped, it takes two minutes to restart.
button for one second to display the set point value, then
.
again to confirm the new value.
28
and/or buttons until