Snapper XD Manual Del Propietário página 18

OPERATION
W A R N I N G
Make sure that the battery doors are locked into place or the machine will not start.
STARTING AND STOPPING (See Figure 7)
1. Press the power button.
2. Turn the switch to the corresponding battery to be used. Note that a
battery must be present in that location for the unit to function.
3. Turn the switch to the center position and press the power button to turn
off the machine.
4. Press the speed control to adjust the suction power.
NOTE: If the switch is turned to the center position the suction stops but the
machine is still powered on. The unit will remain on for a certain period of
time without use or will turn off if the user presses the power button.
NOTE: The machine is built with a thermal protector to stop the motor when
overload occurs. It's a device calibrated to open the motor circuit upon
reaching a certain temperature/current. Re-setting the protector requires both
cool down below the calibration point and removal of battery packs. When the
protection happens, the operator should turn off the machine and remove the
battery packs immediately, then restart operation after at least 30 minutes.
POWER
BUTTON
18
SPEED CONTROL
SWITCH
DRAIN CAP
Fig. 7