Vacuuming Tips - Snapper XD Manual Del Propietário

OPERATION
BLOWING FEATURE (See Figure 8)
The vacuum can blow sawdust and other debris. Do the steps below to use
your machine as a blower.
1. Insert the hose into the blowing port.
2. Insert the desired accessory into the end of hose.
3. Start the machine.
BLOWING PORT
W A R N I N G
Do not put any object into the openings when you use the machine as a
blower. Do not use with any opening blocked. Keep free of dust, lint, hair, and
anything that may reduce air flow.

VACUUMING TIPS

1. The filter must always be in the correct position at all times to avoid leaks
and possible damage to the motor.
2. When using your machine to pick up fine dust, it will be necessary for you
to empty the collection tank and clean the filter at more frequent intervals
to maintain peak vacuum performance.
3. The filter must be dried to avoid possible mildew and damage to the filter
after you use the machine to pick up liquids.
4. Leave a gap at the tip of the nozzle opening to allow air inflow when you
vacuum large quanties of liquids.
5. When the collection tank reaches the maximum capacity, the suction
action will stop. When this happens, turn off the machine, turn the drain
cap to drain the liquid.
19
Fig. 8