Cardin TXQ449100 Datos Técnicos, Dibujos Técnicos De Instalación Y Referencias página 16

Setting a language:
Press a key to reach menu 7, press
keys and then press
Setting the relays
The display type receiver S449 uses an "Impulsive" type relay that can be programmed by means of the
menu "IMP. STRIP" to work as an "On-Off" or "Timer" relay. To set the strip press on of the arrow keys
until you reach menu 5, press
Press to confirm and the current status of the relay will appear on the display. Using the arrow keys
ENT
choose between 'ON/OFF' - 'IMPULSIVE' - 'TIME' and press
option you will be taken into a sub menu where you can set the time that the relay will remain active for
(from 1 to 255 seconds). Use the arrow keys to choose the desired time and then press
default setting is impulsive).
TRANSMITTER CODE MANAGEMENT
Attention! Before memorising the transmitters for the first time remember to cancel the entire memory content.
Memorising a channel
• Scroll to menu "1) MEMORIZE TX", press
• Press the channel on the transmitter you wish to memorize, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
- the symbol '+' indicates that a channel has been added;
P 1
200000001
SN
the symbol '=' indicates that the channel already exists
-
P 1
SN 200000001
Note:
(1) you cannot memorize a transmitter that has already been memorised: in this case the symbol '=' will
appear on the LCD display.
(2)
when the memory is completely full, the buzzer will sound 5 "beeps" one after the other and the indica-
tion "E03- memory full" will appear on the display.
Cancelling a channel using a transmitter
• Scroll to menu "2) CANCEL TX", press
• Press the channel on the transmitter you wish to cancel, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
- the symbol '-' means the channel has been cancelled.
- means that the channel is not present in memory.
NON TROVATO!
Cancelling one or more channels by means of memory position:
• Scroll to menu "3) CANCEL POS.", press ENT and "Location 1" will appear on the LCD display, press
an arrow key
the chosen position will appear on the LCD display (e.g. A B _ D).
• Using the keys move the cursor to the desired channel, press
the letter. Repeat the procedure for all the channels you wish to cancel.
• Move the cursor to OK and press
with the asterisk symbol
Note:
(3) If the chosen location is free 'FREE!' will appear on the display
(4)
If you cancel all the activated channels the transmitter will have been eliminated from the system and
"ELIMINATED!" will appear on the display.
ENT
again (the default language is Italian).
ENT
and then choose a channel A - B - C - D to set using the arrow keys.
ENT
ENT
to scroll to the location you wish to cancel, press
. "WAIT....." will appear on the display and the channels marked
ENT
* will be cancelled
, choose one of the five available languages using the
to confirm. If you choose the "TIME"
ENT
and "Activation 1" will appear on the LCD display;
ENT
(1) (2)
and "Activation 1" will appear on the LCD display;
(4)
.
16
to confirm (the
ENT
(2)
.
(3)
, the channels present in
ENT
and the symbol *
ENT
will replace