Cardin TXQ449100 Datos Técnicos, Dibujos Técnicos De Instalación Y Referencias página 23

The answer from the receiver follows a rigid structure (an example is shown
to the right) in which all the available information is shown.
The visual aspect of the answer is determined by the display settings of the
appliance it is shown on and could differ from the example we have given.
The upper part shows the product data (name and article nr.) and firmware
version and release date.
The lower part shows the status of the receiver at the moment the answer
is sent and after the requested variations have already been carried out.
To represent the CAR status three indications are used: "OK" indicates a normal condition, "CHANGED"
indicates that a variation of the code has been carried out successfully, "ERROR" indicates that the code
is no longer available.
(1)
The next four lines , one for each receiver function, give information about the status of the indicated
channel as follows:
- the channel identification acronym is at the beginning of the row (the same acronym found on the
printed circuit);
- the active function mode is then shown in brackets
- the status of the strip is indicated at the end of the row, after the '=' symbol (ON=active, OFF=inactive)
(1)
In the case of a CAR error the message is reduced by omitting the channel status.
ERROR SITUATIONS
• The receiver is fitted with error diagnostics. The error situations are indicated on the display by the symbol "E"
flashing followed by an error identification number. The error numbers are as follows:
Code Message
E01 MISSING MEMORY
E02 PARAMETERS
E03 FULL MEMORY
E04 MEMORY
E05 FORBIDDEN
E06 SYSTEM
E07 PIN ERROR
E08 CORRUPT PIN
E09 SIM CODES
E10 CAR CODE
The error codes E07-E08-E09-E10 derive from functions that are only available through the use of a
PGM449 or software. Consult the instructions supplied with the specific product for more information.
If the error persists contact the after sales service.
Error description
The memory chip M1 is missing or damaged
Insert or replace the memory chip M1
Receiver base parameter error
The corrupt parameters will be replaced with default values
Full memory
all memory locations have been occupied
Generic memory error
Memory access problem. Repeat the operation.
Illegal operation.
General system error.
PIN code error
The code was automatically reconstructed
The PIN code cannot be reconstructed
The receiver will remain blocked and will not respond to commands
SIM code error
The GSM card cannot be used
Remote activation code error
The function has been disabled
23
RCQ4XXGSM
0.8d
28-08-2012
----------------
CAR CODE = OK
CHA (IMPULSE) = ON
CHB (TIMER ) = OFF
CHC (IMPULSE) = OFF
CHD (ON/OFF ) = ON