Cleaning And Storage; How To Clean; Storage; Troubleshooting - Vornado VH102 Guia Del Propietario

Cleaning and Storage

How to Clean

Your heater has no user serviceable parts. Do not disassemble the
†
unit. This will void your warranty. If service is required, return your
heater to Vornado (see WARRANTY for instructions).
The motor is permanently lubricated and requires no oiling.
†
Because your heater moves a substantial amount of air, it will need
regular cleaning. To clean follow these simple instructions:
1.
Unplug the unit.
Note: Do not use gasoline, thinners, solvents or other chemicals for
.
cleaning
2.
Use the brush attachment on your household vacuum cleaner to
vacuum any accumulated dust off the Front Grill and Side Air In-
lets. Wipe down the entire surface with a soft cloth.
8 English

Storage

During the off-season or after extended periods of non-use, you may
choose to store your heater. To ensure long life of the product, it is
recommended to store your heater by following these instructions:
1. Unplug power cord and bundle loosely.
2. Thoroughly clean your heater (see HOW TO CLEAN for instruc-
tions).
3. Cover, or place back in retail carton if available. This will prevent
the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
Problem Possible Cause and Solution
Unit fails to power on. Unit is not plugged in. Plug Power Cord into electrical outlet.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse (See OPERATING TIPS).
The unit has overheated. Automatic Safety Shut-Off has initiated (See RESETTING YOUR VORNADO HEATER).
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit is not producing Ensure unit is set to High Heat and thermostat is set to highest Temperature setting.
sufficent amount of heat.
Close all doors and windows to trap heat.
Allow the unit to fully circulate the heat throughout the room, may take several minutes.
† In smaller areas, you might prefer to set the Fan switch to Auto. In the Auto
position, the fan will come on only when the heating element is on.
† In larger spaces, your Vornado® Heater, will function most effectively with the
Fan switch set to High or Cont. In the High or Cont. position, the vortex beam
of air will gently keep the air circulating in the room for even, uniform heating.
† Your heater can function as a personal fan for cooling. Set the Thermostat to
Fan Only and set the Fan switch to High or Cont.
† Your heater, like any other 1500 watt electric heater, draws up to 12.5 amps of
electric current. If using your heater on High Heat causes your home's circuit
breaker or fuse to trip, we offer the following suggestions:

Troubleshooting

Operating Tips

† Try turning off other electrical appliances that run on the same circuit as
your heater.
† Run your heater on Low Heat.
† Have your electrician add an additional circuit to your home's electrical system.
When the room temperature is higher than the set temperature it is normal and
correct to have little to no heat coming out of the VH102 or VH2. When the unit
is first turned on there is a slight delay before heat will start to be produced.
† ALWAYS USE COMMON SENSE WHEN USING THIS AND/OR ANY
ELECTRICAL APPLIANCE.
English
9