Noblex NW100 Instrucciones Para El Uso página 32

•
Rotate it until the mark is exactly between the battery compart-
ments.
A suitable counterpart to your optics can be attached to the
M52x0.75 thread on the opposite side.
ADJUSTMENT AND INSTALLATION OF ATTACHMENT DEVICE
INSTALLATION OF THE ADAPTER
The device is used as an attachment unit by means of standard adapters
(e.g. Rusan) and the bayonet adapter (thread M52x0.75). The following
procedure is recommended:
1. Connect the bayonet adapter and clamp adapter together
2. Position the clamping lever so that it is easily accessible.
3. Fix the position with the counter ring (screw lock can be used but it can
be very difficult to open it again)
4. Push the pre-assembled clamping adapter onto the rifle scope and press
firmly against the rifle scope from the front so that it lies flat.
5. Close the lever (clamping force can be adjusted using a special tool)
6. If the installation is not carried out correctly, it can tilt and thus cause
the hit point will be offset.
32