Lenco PIR-645 Manual De Usuario página 12

1. Press and hold Info/Menu button, turn "-Vol+/OK/Tune" button to select 'DRC', and
then press "-Vol+/OK/Tune" button to confirm.
2. Turn "-Vol+/OK/Tune" button to select through 'DRC high', 'DRC low' or 'DRC off',
then press "-Vol+/OK/Tune" button to confirm.
Station order
You can choose the order of the DAB station list to be either Alphanumeric or Ensemble.
1. Press and hold Info/Menu button, turn "-Vol+/OK/Tune" button to select 'Station
order, and then press "-Vol+/OK/Tune" button to confirm.
2. Turn "-Vol+/OK/Tune" button to select through 'Alphanumeric' or 'Ensemble', then
press "-Vol+/OK/Tune" button to confirm.
Viewing Station Information
DAB stations broadcast additional information. Press Info/Menu button on the main unit
repeatedly to view information through DLS (Dynamic Label Segment), Ensemble, Program
Frequency, Signal Quality, Signal Strength, Bitrate, Codec, Channel and Date.
FM Mode
Selecting FM Mode
1. Press Mode button to choose FM Radio.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz).
Otherwise, the last listened FM station will be selected.
3. To manually change the FM frequency, while FM frequency shows up, press Station
button first, then turn "-Vol+/OK/Tune" knob to change the frequency by 0.05MHz.
4. To automatically scan, while FM frequency shows up, press "-Vol+/OK/Tune" knob to
search the next available station.
Scan setting
By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press
and hold the Info/Menu button, turn "-Vol+/OK/Tune" knob to select 'Scan setting',
then press "-Vol+/OK/Tune" knob to confirm.
2. Display will show 'Strong stations only?', turn "-Vol+/OK/Tune" knob to select "YES"
or "NO" to confirm.
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result
in a poor signal-to-noise ratio (hiss).
1. To play weak stations in mono, press and hold Info/Menu, turn "-Vol+/OK/Tune"
knob to select 'Audio setting', and then press "-Vol+/OK/Tune" knob to confirm.
2. Display will show 'Listen in Mono only?', turn "-Vol+/OK/Tune" knob to select "YES"
or "NO" to confirm.
12