Using The Appliance For The First Time - Fulgor Milano F7BC24 Series Mantenimiento

• Coffee has been used to factory test the appliance and
it is therefore completely normal for there to be traces of
coffee in the mill.
• Customise water hardness as soon as possible following
the instructions in the "Setting water hardness" section.
1 Connect the appliance to the mains supply.
Set the required language.
2 To set the language, use the
choose the required language (fig. 2). When the message
"PRESS OK TO CHOOSE ENGLISH" is displayed, press
the OK icon (B9) (fig. 3) for 3 seconds until "ENGLISH
INSTALLED" is displayed. If you set the wrong language,
follow the instructions in the "Setting the language"
section.
If your language is not available, select one from those
displayed. The instructions refer to the English version.
Then follow the instructions displayed:
3 After 5 seconds, the appliance displays "FILL TANK".
Extract the water tank (fig. 4), rinse and fill with fresh
water without exceeding the MAX line. Replace and push
as far as it will go.
4 Place a cup under the hot water spout (fig. 5). (If the
hot water spout is not inserted, the appliance displays
"INSERT WATER SPOUT". Attach it as shown in figure 6.
The appliance displays: "HOT WATER PRESS OK".
Press the OK icon (B9) (fig. 3) and after a few seconds a
little water comes out of the spout.
5 The machine now displays "TURNING OFF... PLEASE
WAIT" and goes off.
6 Extract the appliance by pulling it out using the handles
(fig. 7). Open the lid and fill the container with coffee
beans, then close the lid and push the appliance in.
The coffee maker is now ready for normal use.

5 - Using the appliance for the first time

icons (B7 and B8) to
IMPORTANT!
Never introduce pre-ground coffee, freeze dried coffee,
caramelised beans or anything else which could damage
the appliance.
N.B.!
When using the appliance for the first time, you need to
make 4-5 cups of coffee and 4-5 cappuccinos before the
appliance gives satisfactory results.
N.B.!
Each time you turn the coffee maker on by the ON/OFF
switch (A23), it performs a SELF-DIAGNOSIS cycle and
then goes off. To turn it on again, press the ON/OFF/
STAND BY button (A7) (fig. 1)
EN
13