Making Cappuccino - Fulgor Milano F7BC24 Series Mantenimiento

14 - Making cappuccino

EN
N.B.:
Set the quantity of coffee you want to use to make the
cappuccino in the "Program cappuccino" function in the
menu.
• Select the taste of the coffee you want to use to make the
cappuccino by pressing the
• Remove the lid of the milk container.
• Fill the container with about 100 grams of milk for each
cappuccino to be prepared (fig. 23). Never exceed the
MAX level (corresponding to about 750 ml) marked on
the container. You should ideally use skimmed or semi-
skimmed milk at refrigerator temperature (about 5°C).
• Make sure the intake tube is correctly inserted in the
rubber washer (fig. 24) then replace the milk container
lid.
• Position the frothed milk regulator (C1) between the words
CAPPUCCINO and CAFFELATTE printed on the milk
container lid. The quantity of froth can be adjusted by
moving the regulator towards the word CAFFELATTE for a
denser froth. Moving it towards the word CAPPUCCINO
obtains a less dense froth.
NO froth
"Denser" froth
frothed milk regulator
"Less dense" froth
18
icon (B4).
• Remove the hot water spout (fig 6) and attach the milk
container to the nozzle (fig. 25).
• Position the milk spout as shown in fig. 26 and then place
a sufficiently large cup under the coffee and milk spouts.
• Press the icon (fig. B12). "CAPPUCCINO..." is
displayed and after a few seconds, frothed milk flows
out of the milk spout into the cup below. (La fuoriuscita
del latte si interrompe automaticamente). (Delivery stops
automatically).
• The appliance delivers coffee.
• The cappuccino is now ready. Sweeten to taste and, if
desired, sprinkle the froth with a little cocoa powder.
NOTE 1: While making cappuccino, the flow of frothed
milk or coffee can be interrupted by pressing the
icon (B12).
NOTE 2: If the milk in the container finishes while delivering
frothed milk, remove the container and add milk.
Reattach and press the
cappuccino again.
NOTE 3: To ensure the complete cleanliness and hygiene
of the milk frother, always clean the circuits in the
milk container lid after making cappuccino.
"PRESS CLEAN!" flashes on the display.
• Place a recipient under the milk spout (fig. 26).
• Press the CLEAN button on the lid (C3) and hold down for
at least 5 seconds (fig. 26) to start the cleaning function.
The appliance displays the message "CLEANING!" above
a progressive bar. You should not release the CLEAN
button until the bar is complete indicating that cleaning
is concluded. When the CLEAN button is released, the
function stops. After cleaning, remove the milk container
and place in the refrigerator. The milk should not be left
out of the refrigerator for more than 15 minutes.
NOTE 4: To change the quantity of coffee or frothed milk
the appliance delivers automatically into the cup,
proceed as described in the section "Changing
the quantity of coffee and milk for cappuccino".
(B12) to request a