Setting Water Hardness; Programming Coffee; Programming Cappuccino; Programming Water - Fulgor Milano F7BC24 Series Mantenimiento

EN

Setting water hardness

The operating period can be extended if required, making
descaling less frequent by programming the machine on the
basis of the real lime content in the water used.
Proceed as follows:
• remove the "Total Hardness Test" strip (attached to page
2) from its packaging then dip it fully in the water for a
few seconds, Then remove and wait about 30 seconds
(until it changes colour and forms red squares).
• turn the appliance on by pressing the ON/OFF/stand-by
button (A7).
• Press the icon (B2) to enter the menu and then the
icons (B7) and (B8) until "WATER HARDNESS" is
displayed.
• Press the OK icon (B9).
• Press the icons (B7) and (B8) until the number
coincides with the number of red squares on the test strip
(for example, if there are 3 red squares on the test strip,
select the message "WATER HARDNESS 3"
• Press the OK icon (B9) to confirm.
The coffee maker is now programmed to provide the
descale warning when actually necessary.

Programming coffee

For instructions on
"CHANGING THE QUANTITY OF COFFEE IN THE CUP"
section.

Programming cappuccino

For instructions on programming cappuccino, see the section
"CHANGING THE QUANTITY OF MILK AND COFFEE FOR
CAPPUCCINO".

Programming water

For instructions, see the "CHANGING THE QUANTITY OF
HOT WATER" section.
24
programming coffee, see

Descaling

IMPORTANT!
Descaler contains acids.
Respect the safety warnings provided by the manufacturer
and given on the descaler pack.
N.B.:
Use the descaler recommended by the manufacturer only.
Use of other descalers invalidates the guarantee.
Failure to descale the appliance as described also
invalidates the guarantee.
When "PLEASE DESCALE !" is displayed, the machine
requires descaling.
Proceed as follows:
• make sure the machine is ready;
• Press the icon (B2) to enter the menu and then the
icons (B7) and (B8) until "DESCALE" is displayed.
• Press the OK icon (B9).
The message "ADD DESCALER PLEASE CONFIRM" is
displayed.
• Empty the tank of water, pour the contents of the descaler
the
bottle into the tank respecting the instructions given on the
descaler pack, then add water..
Position a container with a capacity of 2 litres under the
hot water spout.
• Insert water spout
• Press the OK icon (B9). Descaler flows out of the hot water
spout into the container below.
The appliance displays: "DESCALING".
• The descale programme automatically performs a series
of deliveries and pauses.
• After about 30 minutes "DESCALE COMPLETE PLEASE
CONFIRM" is displayed.
• Press the OK icon (B9). "RINSING FILL TANK" is displayed.
• Empty the water tank, rinse to eliminate descaler residues,
then fill with clean water.
• Replace the tank full of clean water.
"RINSING PLEASE CONFIRM" is displayed again.
• Press the OK icon (B9) again.
Hot water flows out of the spout into the container below
and "RINSING" is displayed.
• Wait until "RINSING COMPLETE PLEASE CONFIRM" is
displayed.
• Press the OK icon (B9).
"DESCALE COMPLETE" is displayed, then "FILL TANK!".
Fill the tank again with clean water.
• The descale programme is now terminated and the
appliance is ready to make coffee again.
NOTE: If descaling is interrupted before completion, the
process must be begun again from the beginning.