Whirlpool IM9 Instruciones De Utilizo página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

E021001CW
The display will show "PR 1"; the machine is
ready to start. If you want to change the
programme please press the required key. Every
time you select a program by pressing the
appropriate key the display will show the chosen
programme: "PR 2", "PR 3", "PR 4" etc.
The cycles of the selected programme are shown
by led on the right side of the keyboard, so that it
is possible to know if prewashing, washing ,
rinsing and spin are included in a program.
At the same time the lower side of the keyboard
shows the detergents that are used during the
washing.
In the coin op version, during the program, a
count down on the display advise the user about
the time to the end of the program.
6. HOW TO START A PROGRAM
After closing the door glass and selecting the
program the display shows the chosen program
(for example "PR 1"), it is possible to start the
program pushing "START". The temperature of
the inner drum will appear in C degrees on the
display (for example "26° C") .
During the cycle the display shows the running
program every 40 seconds (for example "PR 1") .
The led highlighted in the pictures allow to
understand, during the machine function, which
cycle is going on.
Examples: during the first spin, the relative led
flash, interrupted by a long break; during the
second
spin,
the
interrupted by a long break; during the first rinse,
the relative let flash interrupted by a long break;
and so on.
All the program cycles can be identified using the
same logic.
7. DETERGENTS
During the selection of a programme the
detergents that can be used are pointed out on
the lower side of the timer: detergent for
prewashing, washing, softening agent for the last
rinsing.
While the machine is working it is possible to see
when it is time to add detergent in the proper
compartments: the display shows "DETERGENT"
through the appropriate led. When the detergent
finishes definitely, the light turns off.
8. FAST ADVANCE AND STOP
While the program is working, it is possible to
press "ADVANCE" to speed up the running cycle.
A longer pressing of the button allows to speed
11
26/11/04
relative
led
flash
twice,

Publicidad

Tabla de contenido
loading

Tabla de contenido