Shutdown Section; Setting The Motion Detection - THOMSON 512320 Manual De Usuario

d - CONFigurATiON
t c . ) .
2.6 - "ETEINDRE" (SHUTDOWN) SECTION
You can shut down or start up your equipment by
clicking on the relevant button. You must enter a
user name and password (default: User "admin",
leave password blank).
2.7 - SETTING MOTION DETECTION
While the quick configuration wizard is running, you
have the option of programming the recordings for
motion detection for each of the cameras. To set
the sensitivity and the monitoring area for each of
the cameras, go to "Paramètre" (Settings)/"Entrée
filaire" (Wired input)/ "Mouvement" (Movement):
16
en
Plug and Play 4 channel colour
network video recorder
7 8
1 Motion detection activation/deactivation
2 Relevant channel number
3 Activation/deactivation of an audible beep
during detection
4 Set the sensitivity from 1 (weak) to 8 (the
most sensitive)
5 After pressing this button the image of the
camera appears on the screen and a grid is
displayed. Click or draw the areas on the
screen: the red boxes are controlled by your
device. The transparent areas are ignored
by the motion detection function.
6 Corresponds to the recording time triggered
by motion detection, set from 30 secs to 5 mins
7 Select which camera(s) must start recording
when the selected camera detects movement.
For example, you can trigger recording
by 2 cameras when the active camera
detects movement.
8 When ticked, an indicator appears on
the screen to show that detection is activated
9 Tick to send an email if movement is
detected
10 Tick for the camera image to be displayed
on the full screen when movement is
detected
11 Click "Sauver" (Save) after making
modifications to save your settings
1 2 3 4 5 6
9 10 11