AFA AFLZ01 Manual Del Propietário página 8

CAUTION — TIPS FOR REMOVAL OF OLD SHOWER:
Always turn off water supply before removing existing diverter or disassembling the valve.
Open shower handle to relieve water pressure and ensure all water has been drained.
Option 1: Easy Install（No drilling required）
1
T-12
Remove the existing showerhead arm
by turning it in a counter clockwise
direction.
Note: A channel lock wrench T-12
(Not included) may be required.
4
T-2
1/2"
Connect the Supply Adapter (1) or (2)
and turn clockwise with 1/2" Allen
Wrench T-2 (Included).
INSTALLATION
2
m i n 1
- 3 / 8 "
Shower wall surface
Measure
the
distance
between
the
1/2"-14 NPT (National Pipe Thread)
in wall water supply elbow (not included)
and the nished wall surface.
If measurement is between 1-7/8"- 4"
then use supply adapter #2. If distance
is less than 1-3/8" choose 3-1/8"
supply adapter #1.
5
1
Seal the wall around the elbow using
Silicon Sealant T-7 (Not included).
CAUTION: Failure to seal the wall
may result in water damage.
8
3
Wrap 1 (one) layer of Plumber's Tape
T-1(Included) on the threaded side of
the Supply Adapter (1) or (2).
6
2
T-7
1
Insert one end of Shower Arm (3) into
Supply Adaptor (1) or (2).
1 2
T-1
3
2