Shortening The Pa Liner; Cleaning The Torch Neck - Abicor Binzel ROVO VTS Serie Instructivo De Servicio

VTS torch system

9.3 Shortening the PA liner

1
7
1 PA liner
2 Wire conduit
3 Wire feeder
Fig. 11 Shortening the PA liner

9.4 Cleaning the torch neck

2
6
ABICOR BINZEL-
4
5 Nut
1 Sharpen the beginning of the PA liner (1) to approx. 40° with the
ABICOR BINZEL sharpener.
2 Slide PA liner (1) through the wire conduit (2) until a noticeable resistance
(7) is felt.
3 Slide holder nipple, O-ring and nut (4) on the PA liner (1) and tighten the
nut (4) under forward tension.
4 Slide PA liner (1) through the central socket into the wire feed unit (3) .
5 Mark a PA liner (1) that is too long in front of the rolls and disconnect central
connector (5) .
6 Cut the PA liner (1) at the mark with the ABICOR BINZEL cutter (4) .
7 Sharpen the cutting point.
In order to increase the system availability of the welding robot, the
ABICOR BINZEL offers the option of automated torch cleaning.
1 Remove gas nozzle.
2 Remove welding spatter and spray gas nozzle with ABICOR BINZEL anti-
spatter agent.
3 Check all other wearing parts (contact tip, spatter protector, tip adaptor) for
visible damage and replace them, if required.
4 Replace equipment kit (wire guide torch neck) when worn or soiled.
5 Clean separating point and grease O-rings with grease (free of silicone and
acid). Grease is included in the scope of delivery.
 4 Scope of delivery on page EN-7
9 Maintenance and cleaning
5
Cutter 6 Central connector
7 Stop
3
4
EN - 19