Stoelting C111-37 Manual Del Propietário página 3

4 UNPACK THE MACHINE
1 Take the machine out of its packaging, which we
recommend you keep for future requirements.
2 Make sure that the machine has not been damaged during
transportation. If this is the case, immediately make a claim
with your carrier.
NOTICE: Do not lay the machine on its side or back.
NOTICE: Do not lift the machine by the tank, auger, or
handles. Only lift by grasping the bottom of the machine.
NOTICE: The machine must sit in the upright position for 24
hours before turning it on. This will allow the oil in the
compressor to settle into place following shipping.
3 Place the machine onto a counter designed to withstand its
weight, including when full.
4 Leave a clearance of at least 6" around the whole machine
to avoid obstructing the cooling air flow.
5 Check the stability of the device, adjusting the height of the
legs if necessary. If the dispenser is provided with taller legs
(approximately 4"), these must replace the original ones.
ATTENTION
Make sure the machine is properly grounded, otherwise
you may cause electric shocks to persons or damage to
the machine.
6 The machine does not leave the factory washed and
sanitized. Before use, it must be disassembled, washed and
sanitized, following the instructions in 6. 4 CLEANING.
IMPORTANT
Position the machine in such a way that the power sup-
ply cable is easily accessible.
5 TO OPERATE SAFELY
1 Do not use the machine before reading this instruction
manual first.
2 Do not use the machine unless it is properly grounded.
3 Do not operate the machine if the panels are not in place
and secured with screws.
4 Do not insert your fingers in panel louvers or spigot outlet.
5 Do not remove parts or panels for cleaning or maintenance
without first making sure the machine is disconnected from the
electricity supply.
6 The cover must remain closed at all times.
6 OPERATING PROCEDURES
IMPORTANT
Before use, clean and sanitize the machine according to
the instructions provided in 6. 4 CLEANING.
IMPORTANT
If the spigot assembly has not been installed, the
machine cannot operate and the display shows the
spigot assembly open icon (see figure 1).
This machine is equipped with a hopper designed to keep the
mix refrigerated and a freezing cylinder for the production of the
soft serve.
Every time soft serve is dispensed, the same quantity of soft
serve mix feeds into the freezing cylinder from the hopper.
In order to obtain softer and lighter soft Serve, make sure that
the carburetor is installed correctly. (see figure 2)
For best results, the following steps must be performed in the or-
der specified:
1 Insert the lower part of the carburetor into the mix inlet tube
3
figure 1
figure 2