Preliminary Checks - RIB R-CRX 2.0 Manual Del Usuario

G
B

5. Preliminary checks

Preliminary checks must be executed by qualified personnel only, paying the maximum attention . The correct wiring of the motor is very important for a correct functioning of the automation.
After having checked the wirings and verified that there are no short
1
circuits, unlock the motor and power the system.
2
Press the cabled button open.
3
Press the cable button close.
NOTE - when the control unit will be activated, it emits 2 beeps to signal the correct start up.
6. Learning a transmitter through the "RADIO LEARN" key of the control unit
STOP THE AUTOMATION
ch: A ch: B
NOTE:
If DIP 4 OFF - With a SUN / MOON 4CH remote control it is possible to associate the C and D keys to another R-CRX control unit (2 control units can be managed in total)
If DIP 1-2-4 ON - With a SUN / MOON 4CH remote control it is possible to associate the A-B-C-D keys to 4 different control units (4 control units can be managed in total)
To enable the learing procedure press and release
the "RADIO LEARN" button.
The buzzer emits long beeps each second (for 20
seconds)
YES
While buzzer emits long beeps each second, press
and release the "A" button of the transmitter.
The buzzer emits two long and two short beeps.
YES
If DIP 4 OFF: The 2 buttons "A" and "B" of the remote control are memorized
simultaneously and the procedure is finished.
If DIP 1-2-4 ON: Only the button pressed on the remote control is memorized and
the procedure is finished.
Repeat the procedure if you wish to learn a new transmitter.
Check the status of the signalling LED "photo", "stop" considering that
all the inputs normally closed must have the correspondent led lighted.
• The automation opens. Correct functioning.
• The automation closes => reverse the connections between the clamp
13 and 14.
• The automation closes. Correct functioning.
• The automation closes => reverse the connections between the clamp
13 and 14.
Check that the automation is still.
NO
If the buzzer emits a long bip and two short ones, the
transmitter was already been memorized.
If the buzzer does not make any signal verify that the
NO
transmitter works and belongs to the SUN/MOON Series
and that the battery is charged or repeat the procedure
with another transmitter.
18
ch: C ch: A
ch: B
ch: D