Caution; Installation; Installing The Monitor - Alpine eX-10 Manual De Operación

Installation

Installing the Monitor

CAUTION

Do not install the monitor near the front
passenger seat air bag system.
1
Install the monitor on the stand securely.
Install the monitor on the stand by aligning its back through
the bracket of the stand.
Monitor
Bracket
2
Check the mounting location.
A Temporarily fasten the stand with adhesive tape.
B Adjust to a safe, viewable position.
Line of
sight
In order to use safely, attach to the following places.
• Stable and secure places.
• Places that will not have your view blocked by the main unit
when driving.
• Places that you will not hit against if you lean forward while you
wearing your seatbelt.
• Places where the main unit cannot hit against the steering wheel
while driving.
• Be aware that if the surface of the dashboard is leather, wooden
panel, stretched fabric or any non-resin based product, then the
surface will be damaged when you remove the stand.
Stand
• Do not place the main unit directly in front of the air conditioner vents.
3
Remove the monitor from the stand.
• When you take the monitor out of the car, remove the monitor from
the stand by referring to step 3.
When you install the monitor, refer to step 1.
4
Install the stand using the supplied double-sided
adhesive tape. Remove any dirt on the surface to
install, using the supplied cloth.
Double-sided
Adhesive Tape
• If the temperature in the car is low (Winter), then first heat up the
place where you are going to stick the mount with a hairdryer, etc.
• Do not apply force to the mount, or expose to humidity, within 24
hours after attaching.
• If the mount is not firmly stuck, then we recommend that you attach
with the supplied fixing screws. (For installation, refer to page 20.)
Monitor
If the main unit invades
Dashboard
your line of a sight then
it will block your view.
19
-EN