Rear Panel - Shure ANIUSB-MATRIX Guia Del Usuario

Rear Panel

sig/clip
in
out
usb
① Level Indicators (Signal/Clip)
Tri-color LEDs indicate the audio
signal level for the analog channels
and connectivity status for the USB
channel. Adjust output levels in the web
application to avoid clipping.
Analog Input/Output
LED State
Off
Green
Yellow
Red
Note: The input and output LEDs stay off
when metering is set to Post Fader and the
channel is muted in the web application.
USB Audio
LED State Status
Off No USB device connected
Green USB device operating
successfully
Red Problem detected with
(flashing) connected USB audio device
INPUT OUTPUT
Audio Signal Level
less than -60 dBFS
-60 dBFS to -18 dBFS
-18 dBFS to -6 dBFS
-6 dBFS or more
USB
power
network
network audio
encryption
② Audio Input (Block Connector)
Block Pin Assignments:
③ Chassis Ground Screw
Provides an optional connection
for microphone shield wire to
chassis ground.
④ Audio Output (Block Connector)
Balanced audio output connects
to an analog device. Set the
output level in the web application
to match the input sensitivity of
the analog device.
8
PoE
reset
Audio +
Audio -
Audio ground
Audio +
Audio -
Audio ground