Forney JUMP START Manual Del Propietário página 3

IMPORTANT - BEFORE USE
Before using unit for the first time, unit must be charged for a full 26 hours. Do not exceed recommended Initial
Charge Time of 44 hours. Please recharge jump starter a minimum of every 2 months. Always recharge after use.
OPERATING INSTRUCTIONS
1. 2-12 Volt Output Power Port to Conveniently
Operate 12 Volt Accessories
2. LED Work Light
3. Easy Carry Handle
4. Battery Status LED Indicators with Button Switch
5. On/Off Light Switch
6. Convenient Booster On/Off Switch Disables
Booster Use
7. Input Socket for DC Charger
8. Charging & Charged LED Indicators
2
1
CORRECT PROCEDURE FOR JUMPSTARTING A VEHICLE
1. Turn ignition and all accessories such as lights,
radio, air Conditioner, OFF.
2. Make sure all switches on the Jump starter are
turned off (horizontal position for the booster
cable switch).
3. Securely connect the red (+) clamp to your
vehicle battery's positive (+) battery terminal.
4. Connect the black (–) clamp to a non-moving
metal part of the vehicle. Do not connect to the
negative terminal.
4
3
5
8
7
WWW.FORNEYIND.COM
9. Heavy-Duty Impact Resistant Case
10. AC Built-in Plug (back
11. Pressure Gauge for Air Compressor
12. On/Off Air Compressor Switch
13. Circuit Breaker
14. Built-in Rechargeable 18 AH Sealed Lead Acid
Battery
15. Air Hose Nozzle with Accessories
16. Industrial Grade 400 Amp Booster Battery
Clamps 6 Gauge 50" Cables
10 11
6
9
5. Turn Switch on Jump starter to ON (horizontal)
position on side of unit.
6. Start vehicle. If vehicle does not immediately start,
wait 3 minutes before trying again (failure to
wait may damage Jump starter, vehicle's starter
or electrical system). If vehicle does not start
after trying 3 times, check the battery status and
electrical system.
7. After vehicle starts, turn the Jump starter switch
to OFF (vertical) position. Disconnect the BLACK
Negative clamps first then the RED positive clamp.
12
13
14
15
16
3