Forney JUMP START Manual Del Propietário página 4

USIING POWER PORT OF JUMP STARTER
1. Remove the protective cover.
2. Plug in your 12-volt accessory.
3. There is a 15 amp automatic overload protection circuit breaker.
Reset the breaker by pushing the breaker button located on the back of the jump starter.
BATTERY STATUS MONITOR
1. Before checking the battery status and to receive an accurate reading, unplug the AC or DC charging adapter
from the unit.
2. Press and hold the Battery Level Indicator Button.
3. The Battery Level Indicator LEDs will illuminate to indicate the amount of Charge remaining in the Jump starter.
Green Light: Fully Charged
Amber Light: Battery Usable
Red Light: Recharge Necessary – Do Not Use without recharge
4. When you release the button the lights will go out.
CHARGING YOUR POWER PACK PORTABLE POWER SOURCE
1. Completely charge Jump Starter before using for the first time.
2. Before recharging from an AC outlet, be sure the power source is 110-120 volts only.
3. Use only the charger unit provided with unit.
4. Keep the power on/off safety switch in the OFF position while charging.
5. Make sure that there are no 12 V DC appliances connected to the mobile booster pack during charging.
6. Charging time is approximately 48-72 hours (may vary depending upon temperature and battery condition).
FOR AC CHARGING AT HOME
Press and hold the battery level indicator button to the left of the LED lights to determine your battery level of the
power pack. Recharge when the battery level is less than 75% (Amber or Red LED lights).
1. Plug extension cord into charger plug on the back of the power pack.
2. Plug the extension cord into 120V AC source. (Electrical outlet)
3. The red LED will glow indicating the internal battery is charging.
4. The green LED will glow when the battery has reached full charge. This could take up to 72 hours depending
on the age and condition of the battery.
FOR DC CHARGING IN YOUR VEHICLE
When engine is running
1. Plug the DC charging cord into the DC charger input socket on the front panel.
2. Plug the DC charging cord into any 12V vehicle cigarette or power supply.
WWW.FORNEYIND.COM
4