Troubleshooting - Forney JUMP START Manual Del Propietário

USING THE COMPESSOR
To use the compressor. Open the compartment door located on the back of the unit and pull out the air hose.
Make sure the nozzle lever is in the up position. Place the nozzle over the valve stem of the tire and press down on
the lever to lock it in position. Turn the compressor on/off switch to the "ON" position. Monitor the pressure gauge
while inflating. When desired pressure has been reached, turn compressor "OFF" and disconnect the hose.
For inflating other articles. Select the appropriate adaptor and insert it into the hose nozzle. Press lever down to
lock in place. Inflate object as above.
WARNING: Run the compressor only for 10 minutes at a time continuously, then leave it off for 10 minutes before
using again. So that the compressor can cool.
Note: For athletic balls. Moisten needle before inserting it into the ball valve. For other pneumatic articles, the
nozzle should be inserted into the valve and held tightly to insure a good seal.

TROUBLESHOOTING

PROBLEM
The booster pack won't
jump start my car.
The booster pack won't
power my 12V device.
The battery in the booster
pack won't hold a charge.
POSSIBLE CAUSE
Clips are not making a good connection
to the battery.
Connections are reversed.
The booster pack battery is not
charged.
The 12V devise is not turned on.
The booster pack battery is not
charged.
The 12V device draws more than a
15A or has a short circuit.
The battery is bad (will not accept a
charge).
WWW.FORNEYIND.COM
SOLUTION
Check for poor connection to battery and
frame. Make sure connection points are
clean. Rock clips back and forth for a better
connection.
Disconnect the booster pack and reverse
the clips.
Check the battery charge status by pressing
the button on the front of the booster pack.
See LED Indicators section of this manual.
Turn on the 12V device
Check the battery charge status by pressing
the button on the front of the booster pack.
See LED Indicators section of this manual.
Disconnect the 12V device and press the reset
button located on the back of the booster pack.
Try the 12V device again. If it happens again,
replace the 12V device.
Have the battery checked.
5