Cleaning And Maintenance; Safety Information; Cleaning - Caso Whole Slow Juicer Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 85

16 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

16.1 Safety information

Attention
Please observe the safety instructions, before cleaning your device
► Unplug the can opener when not in use and before any cleaning.
► Never immerse the unit, cord or plug in water or other liquids and do not place in the
dishwasher.
► Do not use iron brush, abradant, kitchen cleaner, or sharp cleaning tool for cleaning.

16.2 Cleaning

Please note
► You can use the provided cleaning brush.
► Extract all the remainung pulp in the juicing bowl before stopping the juicer.
► For easier clean up, operate the juicer for an additional 30 seconds after the juice is
extracted.
► When the drum lid is stuck, press the REV(II)-O-ON (I) button in this order,switching
back and forth 2 to 3 times to dislodge. Then place hands on top of the drum lid and
firmly press down simultaneously turning the drum lid counter clockwise to open.
1. Switch off and unplug the power cord from the wall outlet.
2. Remove the pusher.
3. Turn the feeding tube counter clockwise to open.
Please note
► When moving the appliance, do not lift by grabbing the feeding tube. Always lift the
appliance by grabbing the base or handle.
4. Lift up the juicing bowl including the juicing crew, strainer and rotation wiper.
5. Remove the juicing screw, strainer and rotation wiper unit from the juicing bowl.
Please note
► Immediately clean the juicer after each use. If remaining residue in the juicer dries up, it
can make disassembling and clean-up difficult. The excess build up can cause poor
performance in future uses.
► For easier disassembly, place the top-set in the sink and run the water through from the
top of the top-set.
► Thoroughly dry the bottom of the juicing screw where it connects to the metal cylinder
shaft on the base.
6. Place the juicing bowl under running water and unplug the compression silicone to
clean the pulp spout.
Caso Entsafter „Whole Slow Juicer" SJW 400
42

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sjw 400

Tabla de contenido