GiBiDi SC230 Manual De Instrucciones página 12

12
UK
FUNCTION PROGRAMMING (DIP SWITCH-SW1)
The settings are stored during the rest phase (gate closed).
DIP Status
DIP 1 OFF
DIP 2 OFF
DIP 1 ON
DIP 2 OFF
DIP 1 OFF
DIP 2 ON
DIP 1 ON
DIP 2 ON
DIP 3 ON
DIP3 OFF
DIP 4 ON
DIP 4 OFF
DIP 5 ON
DIP 5 OFF
DIP 6 ON
DIP 7 ON
DIP 7 OFF
DIP 8 ON
DIP 8 OFF
DIP 9 ON
DIP 9 OFF
DIP 10 ON
DIP 10 OFF
Function
STEP-BY-STEP WITH STOP
STEP-BY-STEP
AUTOMATIC
DEAD MAN
PRE-FLASHING
SAFETY DEVICE TEST
PHOTOCELL DURING OPENING
AUTOMATIC CLOSING
DECELERATION
FAST CLOSING
MOTOR RPM SENSOR
STOP BUTTON DISABLE
Description
I Start pulse : OPENS
II Start pulse : STOPS (will not reclose automatically)
III Start pulse : CLOSES
IV Start pulse : OPENS
I Start pulse : OPENS
II Start pulse : CLOSES
III Start pulse : OPENS
During opening it does not receive other Start commands after the first one; during Pause
subsequent Start commands reload the pause time
I Start pulse : OPENS
Subsequent Start pulses : Uninfluential
Pause from opening limit switch
Start pulse during pause : Reloads the pause time (if DIP 6 ON)
Subsequent Start pulse : OPENS
If Start button is held down : OPENS
If Pedestrian button is held down : CLOSES
Enables pre-flashing of 2 seconds before motor activation during opening an d closing
Disables pre-flashing
Enables the safety device TEST before activating the opening and closing cycle.
The cycle can only start if the devices work perfectly, if not, three prolonged flashes
indicate the fault.
Disables the safety device test.
When the photocell is intercepted during both opening and closing, the gate motion is
locked until the photocell is freed. Subsequently, there is always an opening phase.
Disables the photocell function during opening.
Enables automatic closing after the pause time adjustable with the trimmer TR1 PAUSE
between 2 and 215 seconds.
Disables automatic closing.
Enables deceleration during both opening and closing when the respective limit switch is
intercepted. The deceleration speed is adjusted with the trimmer TR3 SLOW. This function
provides for use of 4 magnets (see drawing 2)
Disables the deceleration function. Only 2 magnets are required (see drawing 2)
Reduces the pause time to 3 seconds after intervention of the photocells.
Disables the fast closing function.
Enables operation of the motor rpm sensor. After a reduction of the number of motor
revolutions (e.g. for an obstacle) the sensor intervenes locking the motion and inverting the
direction for 2 seconds in order to free the obstacle. At the next Start pulse the motion
restarts in the obstacle freeing direction.
Disables the motor rpm sensor
Disables the STOP input
STOP input enabled
Or CLOSES (if DIP 6 OFF)
SC230