Install Overlay Series Custom Panels; Door Panel Installation - Kitchen Aid Stainless Serie Guia De Instalacion

3. Continue adjusting all of the leveling legs to raise the
refrigerator until the top is within at least 1" (2.54 cm) of the
top soffit.
NOTE: If an anti-tip board has been used, adjust the leveling
legs until the top of the refrigerator is within 1/4" (6.35 mm) of
the bottom of the anti-tip board as shown. Do not crush the
compressor cover.
2" (5 cm)
D
A. Center board 1/4" (6.35 mm) max. above refrigerator
B. 2" x 4" x 32" (5 cm x 10 cm x 81 cm) boards (2)
C. Attach to studs with six #8 x 3" (7.6 cm) screws
D. Compressor cover
IMPORTANT: Adjust in small increments to keep from
damaging the cabinet trim and causing problems with the door
alignment or top grille fit. To avoid damage to the cabinet or
leveling legs, do not apply more than 50 inch-pounds
(5.65 Nm) of torque to the leveling bolts. The leveling legs can
be extended to a maximum of 1¹⁄
4. For Overlay models, additional adjustments may be needed
after the custom panels are installed.

Install Overlay Series Custom Panels

IMPORTANT:
Install the custom handles prior to installing the panels on the
■
refrigerator. For more information on KitchenAid custom handle
selection, refer to the KitchenAid Catalog, visit
www.kitchenaid.com, or call 1-800-442-9991. In Canada,
visit www.kitchenaid.ca, or call 1-800-807-6777.
Create custom door overlay panels according to the
■
specifications in the "Overlay Series Custom Panels" section.
KitchenAid is not responsible for the removal or addition of
■
molding or decorative panels that would not allow access to
the refrigerator for service.

Door Panel Installation

1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer compartment doors.
A B
C
1/4" (6 mm)
max.
" (3.18 cm) below the rollers.
4
3. Remove the handle-side and top trims.
A
4. Slide the custom panels into the bottom and hinge side trims
on the refrigerator compartment and freezer compartment
doors, making sure that the backer panel fits into the hinge
side trims.
A
A. Panels
5. Reinstall the handle-side and top trims.
6. Remove the skin from the screw covers. Slide or snap the
screw covers into the handle trim section.
7. Check refrigerator level and alignment. Adjust if needed.
A. Trims
A
A
19