Before Welding - Toparc MASTER LCD 11 Manual De Usuario

The welding helmet MASTER 11 complies with EEC directives 89/686 CEE. This confirmity is established in compliance with EN 175, EN 166, EN 168 and EN 379.
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.

BEFORE WELDING

-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the 2 sensors (4) and the cell (2) are not obstructed by dust or debris.
-Make sure that the protection films on both screens are removed.
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
The MASTER 11 auto-darkening welding helmet switches from light to dark state when a welding arc is struck. The auto-darkening welding helmet switches back to the light
state when the arc stops.
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result in
irreparable damage to the module.
HEADBAND ADJUSTMENT
The MASTER 11 is equipped with a headband which can be adjsuted in multiple ways to suit the welder: width, height (1), longitudinal inclination (3) and adjustment (2).
MAINTENANCE
• Inspect your welding helmet MASTER 11 regularly.
• The welding helmet must not fall down.
• Do not put any heavy tools/objects in or on the helmet in order not to damage the filter or the protective screens.
• The deterioration of the filter or its protective screen can reduce the vision field or the protection level. Replace the damaged parts.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet preventing proper function, possibly cau-
sing injury or cancellation of the warranty.
• Clean the filter with a clean cotton or with a special rag for lens.
• Clean and change protective screens on a regular basis.
• Clean the inside and the outside of the helmet with a neutral disinfectant product.
• Do not use any solvent.
4
1
Clear shade 3
Dark shade
11
Filter dimension
104x55 mm
Reaction speed 0,0005 s
Power supply Solar
Weight 430 gr
Field of vision 100x49mm
Applications MMA 10>150A / TIG 10>175A / MIG-MAG 10>200A
Warranty 1 year
Application temperature -10°C / + 60°C
Storage temperature -20°C / + 70°C
3
EN
2
1. LCD protection plate
2. Solar cell
3. Filter
4. Sensors
3
1
2
4