Controls And Indicators - Hoover DXW4 H7A1TCEX-S Manual De Instrucciones

6.
CONTROLS AND
INDICATORS
Fi
A
e tra
E
Fi
e tra
C
7 6
A-Programme Selector - Rotating the knob in
both directions it's possible to select the desired
drying program. To cancel the selections or
switch off the dryer rotate the knob on OFF.
B- Display Digit - The display shows the
remaining time for drying, the postponed time in
case of delayed start selection and other
notifications setting.
C-Buttons -
1.Start/Pause Button
To start the selected program and/or suspend it.
2.Delay Start Button
It allows to delay the start of the program from 1
to 24 hours in 1-hour intervals. The delay
selected is shown on the display.
After pressing the START button the time
showed decrease hour after hour.
Opening of the porthole with delayed start set,
after re-closing the porthole, press start again to
resume the counting.
3.Time cycle selection
It's possible transform a cycle from automatic to
programmed, up to 3 minutes after the start of
the cycle.
The progressive pressure increases the time in
10-minute intervals. After this selection to reset
the automatic dying functioning is necessary to
switch off the dryer In case of incompatibility, all
LEDs flash quickly for 3 times.
B
D
5 4 3 1
2
8
4.Drying Selection Button
It allows to set the desired dryness level editable
option up to 5 minutes after the starting of the
cycle:
- Ready to Iron : It leaves the garments
slightly wet to facilitate ironing.
- Dry Hanger : To get garment ready to be
hang
- Dry wardrobe : For laundry that can be
directly stored
-Extra-dry : To get completely dry garments,
ideal for full load.
This appliances is equipped with Drying Manager
Function. On automatic cycles, each level of
intermediate drying, prior to the reaching the
selected one, is indicated by flashing the light
indicator corresponding to the degree of drying
reached. In case of incompatibility, all LEDs flash
quickly for 3 times.
5.Rapids Button
It's possible switch
RAPID program, up to 3 minutes after the start of
the cycle. The progressive pressure increases the
time (30-45-59 minutes).
After this selection to reset the automatic dying
functioning is necessary to switch off the dryer In
case of incompatibility, all LEDs flash quickly for 3
times.
6.Best Ironing
This option allows to reduce folds and tangles,
thanks to alternating movements of the drum
during and after drying and automatically, setting
the ironi drying level (the drying level setting can
be modified after the option selection)
The option ca be set up to five minutes after the
start of the cycle and is activated only on
automatic cycles.
7.Memory
This option allows you to store the options set on
a cycle.
STORAGE When the cycle is running push the
button "memory" for three seconds. The control
light "memory" flashes for three times and stores
the set options connected to the cycle selected in
the flange.
Recall: After the selection of the cycle Push the
button "memory" for recall the stored options.
(not the cycle)
8. Keylock
This function allows to block unwanted changes
of the set options on the bezel , during drying
phase. Activation/Inactivation: Push 4 and 5
buttons simultaneously for two seconds . The
sign "LOC" appears on the display. Unlocking the
option, on the display appears the sign "Unl", only
once. In case of opening of 'porthole' with
activated key lock, the cycle stops but the lock is
kept: to restart the cycle, you must remove the
lock and restore Start. When the dryer is off, the
option is automatically inactivated.
Key lock can be modified at any time of the cycle.
11
an automatic program to