Toothbrush Handle; Brush Head; Charging Base - Philips sonicare DiamondClean HX9339/89 Manual Del Usuario

14
English
Important: Only toothbrush models HX9330, HX9340, HX9350,
HX9360, HX9370, HX939W, HX939B, HX939P, HX939V, HX939L can
be charged in the travel case. Other products and batteries are not
compatible with the travel case.
Note: It takes at least 24 hours to fully charge your Philips Sonicare.
You do not have to fully charge your handle before first use, as the
handle is pre-charged for first use. However, it is recommended to
fully charge it after first use.
Note: This charger is designed to properly charge only one handle at
a time. The charging base is not compatible with other models of
Philips Sonicare.
Note: Do not place metallic objects in the travel case, as handle
charging may be affected and may cause the charger to overheat.
Cleaning
Note: Do not clean the brush head, handle, charging base or USB
travel case in the dishwasher. The glass is dishwasher safe.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm
water. Make sure you remove any residual toothpaste (Fig. 13).
Note: Do not push on the rubber seal on the metal shaft with
sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Note: Do not use isopropyl rubbing alcohol, vinegar or bleach to
clean handle as this may cause discoloration.

Brush head

1 Rinse the brush head and bristles after each use (Fig. 14).
2 Remove the brush head from the handle and rinse the brush head
connection with warm water at least once a week.

Charging base

Use a damp cloth to wipe the surface of the charging base. Make sure
you remove any toothpaste or other residue from the surfaces.