Suntec Wellness Home Essentials BBQ-9479 Instrucciones De Uso página 19

considerable dangers for the user.
• If the connection cable is damaged, it must be
replaced by a qualified person. Please contact your
point of sale.
• No liability is assumed for possible damage if the
device has been used for improper purposes, has
been operated incorrectly or has not been repaired
properly. In such a case, you have no warranty claim.
• When used as a table grill, please remove the hood
to avoid any tipping over.
• Children should be supervised to ensure that they
do not play with the appliance.
• Charcoal or similar combustible fuels must not be
used with this appliance.
Attention: Please be careful. Do not trip over the
power cord when the unit is in use. Please remember
to remove the plug after use.
Components of BBQ-9493
T. Thermometer
1. Handle
2. Upper cover
3. Grill plate
4. Feet
5. Thermoplastic cover
6. Buckle of cover
7. Side table
8. Belt hook
9. Safety lock
10. Support tubes
(The corresponding pictures can be found in the front of this manual.)
Installation of BBQ-9493
1. Please remove the trolley frame and accessories from the box. Make sure that the trolley frame is placed
on a dry, even and stable surface. Insert the wheel axis (a) through the holes provided at the bottom of
the trolley frame. Please attacg tge feet (Z1) to the frame as shown in figure 1.
2. Mount the wheels (b) on the two sides of the axis (a) as shown in figure 2.
3. There are two holes on each end side of the axis (a). Insert the pin "R" (c) through the hole to lock the
wheels (see figure 3).
4. Press the wheel covers (d) on the wheels (b) as shown in figure 4.
5. Place the trolley upright: first step with your right foot on the centre of the carrying tube (I), lift the side
table (II) with your right hand and the wheel tube (III) with your left hand. Then connect the tube (III) to
the tube located under the side table. The trolley frame is now in place (see figure 5).
6. After the trolley frame has been set up, you MUST immediately engage the safety lock (f). This safety
lock is self-locking. Press the spring (s) and hook the curved hook (f) into the extended part (s). Then
stop pressing so that the safety hook automatically engages (see figure 6).
11. Metal hinge
12. Jacket of socket
13. Grease collecting bowl
14. Control knob
15. Removable thermostat with cord
16. Power cord
17. Stand tube
18. Wheel
19. Axis
20. Feet