Grundig ELYA Manual De Instrucciones página 129

LU EN final.fm Page 14 Lundi, 19. octobre 2009 2:44 14
3. Enter your old code first. Each time a digit is entered the «_» is replaced by a «*».
Press menu to confirm.
4. Enter your new PIN code. Each time a digit is entered the «_» is replaced by a «*».
5. Press menu key to confirm your selection. You will hear a confirmation tone.
Note !
Carefully note your base station code. You will need it to change certain settings.
9.2.
Association handset & base
This function allows you to register a new handset on your base.
1. Press menu. Select "advanced set" using the
2. Using the or key, select "registration". Press menu.
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_» is
replaced by a «*».
4. Press and hold key for 5 seconds (after 1 minute if no Handset has started association
process the base goes back to standby).
5. Press menu key to confirm. The display shall show "WAITING" to indicate the waiting state.
6. Once the handset is registered, you will hear a confirmation tone. The handset automatically
exits the registering mode.
7. The handset number assigned automatically by the base appears on the screen.
9.3.
Disassociation of a handset
This function allows you to de-register a handset from your base.
1. Press menu. Select "advanced set" using the
key, select "unregister". Press menu.
2. Using the or
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_» is
replaced by a «*». Press menu key to confirm.
4. Select the handset you want to delete (at standby state, "pls reg h/s" is displayed on the
screen).
You will hear a long beep confirmation tone.
9.4.
Modifying the country
1. Press menu. Select "advanced set" using the
2. Using the or key, select "country". Press menu.
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_» is
replaced by a «*». Press menu key to confirm.
4. Using the or key, select the country where you will use the telephone. Press menu.
5. A confirmation screen appears, press menu.
The message "wait.." appears on the screen. You will hear a confirmation tone.
9.5. Restoring the Handset / Base Default Settings
To restore the factory settings for your Handset or your Base:
1. Press menu. Select "advanced set" using the
2. Using the or key, select "reset". Press menu.
or key, press menu.
or key, press menu.
or key, press menu.
or key, press menu.
- 14 -
English