Heve-5 Vent Enclosure; Special Instructions; Heel-1 90º - COZY HEDV253A Instalación E Instrucciones De Operación

THIS KIT MUST BE INSTALLED BY A QUALIFIED
INSTALLER OR SERVICE TECHNICIAN
Step 1. Position end of Part No. 41610 enclosure body to heater trim kit
where pipes exit trim kit, centering pipes inside body and attach
to wall. Wall anchors (not provided) may be required. Collector
box may be behind HEVE-5 Kit.
Step 2. Cut to fit enclosure panel 1" beyond end of vent run. Insert Part
No. 41620 End Cap and attach using three #8 screws provided.

SPECIAL INSTRUCTIONS:

Step 3. If more than one HEVE-5 Kit is used, attach Part No. 72604
Trim Kit where ends meet.
Step 4. If making a 90º turn, measure 1" beyond outside turn and cut off
enclosure panel.
- Notch panel on surface of direction turn is being made to
allow pipes to pass through into next HEVE-5 Kit.
- Attach second panel to wall and attach Part No. 72604 Trim
Kit where two bodies meet.
- Install end cap Part No. 41620.
1017952-A
HEVE-5 VENT ENCLOSURE KIT INSTALLATION INSTRUCTIONS
HEEL-1 90º ELBOW KIT
Contains 1 only P/N 72613 - (90º Elbow 2")
FIG. 15
Page 16
Back to Index