Safety Precautions; Safety - MANOSTAT E-SERIES 72-410-014 Manual De Operación

DANGER: Remove power from the pump before any cleaning operation is started.
WARNING: Remove power from the pump before attempting any maintenance.
WARNINGS: Tubing breakage may result in fluid being sprayed from pump. Use appropriate measures to
protect operator and equipment.
Turn pump off before removing or installing tubing. Fingers or loose clothing could be caught in
the pump mechanism.
Pinched Finger Hazard — TURN OFF and UNPLUG the PUMP before removing or loading tubing.
CAUTIONS: When changing flow direction, allow the pump to come to a complete stop before starting again.
Failure to do so could cause permanent damage to the motor.
Replace the fuse only with one of the same type and rating. The fuse rating and type are stated on
the rear panel.
These products are not designed for, nor intended for use in, patient-connected applications, including, but not
limited to, medical and dental use and, accordingly, have not been submitted for FDA approval.

SAFETY

1. Read instructions before operating the unit.
2. Observe safety precautions at all times, especially when pumping dangerous liquids. Always have the pump head
cover properly mounted on the pump head and, in general, protect the pump area from accidental spillage of liquid.
3. Pump should not be used in outdoor or hazardous locations.
4. The MANOSTAT E-SERIES pumps should be well-grounded at all times.
NOTE: Use only MANOSTAT Silicone Tubing Links.
E-SERIES — Reg TM Chemtronics, Inc.
Trademarks bearing the ® symbol in this publication are registered in the U.S. and in other countries.

SAFETY PRECAUTIONS

WARNING: PRODUCT USE LIMITATION
4