Bowers & Wilkins CDA-16 Manual De Instrucciones página 7

Specifications
Audio Specifications
Load impedance range:
Output Power per channel, non-clipped:
Output Power bridge mode, non-clipped:
Output Power total, all channels:
DC offset voltage:
Frequency Response (-3dB):
Frequency response accuracy 20Hz-20kHz:
Signal to Noise ratio (Ref. 50W/8Ω):
THD+N (1kHz, 12.5W, 4Ω):
Voltage Gain:
Input impedance:
Maximum input voltage:
Signal sense threshold:
Wake-up time:
Turn-off time:
12V trigger input threshold:
Controls & Indicators
Front panel:
Rear panel:
Connectors
Input:
Output:
12V trigger control:
Power
Power consumption:
AC supply:
AC inlet:
Thermal
Thermal dissipation:
Dimensions
Height:
Width:
Depth:
Net weight:
Finish:
>3Ω per channel (>6Ω in bridge mode)
>50W into 8Ω
>100W into 4Ω
>200W into 8Ω
>400W short term
>200W continuous average
<50mV
<10Hz to >50kHz, any load impedance
±0.5dB
>100dB A-Weighted
typically 0.05%
34.9dB to - infinity, adjustable
15KΩ
6.8V peak (4.8V rms sine wave)
2.5mV (independent of Gain setting)
<0.2s (If other zones active)
<2s (From all zones inactive)
15 minutes from last signal detected
typically 3V (recommended input is 5-15V)
1 x Power LED (unit active – White, Fault – Red)
8 x Zone status LEDs (Signal present – White, Fault – Red)
8 x 2-position DIP switches (link to global input)
1 x 3-position switch (power mode: on, auto detect, 12V trigger)
8 x input gain control with Clip indicator LEDs
8 x RCA (pair) Phono socket, line in (global in shared with Zone 8)
1 x RCA (pair) Phono socket (global out)
8 x 5.08mm Pitch 4-way Phoenix Combicon style
1 x 3.5 mm jack - 12V trigger IN
1 x 3.5 mm jack - 12V trigger OUT (Maximum 100mA pass-through)
<0.5W All zones inactive
<45W All zones idling
300W maximum average
1,000W peak
100-240V 50/60Hz
IEC C14, switched
1.7 BTU/hr (standby),
150 BTU/hr (Idle),
400 BTU/hr (max)
44.5 mm (1.8 in) 1U [55.5 mm (2.2 in) plus feet]
437 mm (17.2 in)
310 mm (12.2 in)
4.5kg (9.9lb)
Black
7