Connecting Electrical Loads - Troy-Bilt 030247-I Instrucciones De Uso

Section 4: Operation
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment to coM before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arresten maintained in
effective working order, complying to USDA Forest service
standard 5100-IC or later revision. In the State of California a
spark attester is required under section 4442 of the California
Public resources code_ Other states may have similar laws.
NOTE: If engine starts after 3 pulls but fails to run, or if
unit shuts down during
operation,
make sure unit is on a
level surface and check for proper oil level in crankcase.
This unit may be equipped with a low oil protection device.
If so, oil must be at proper level for engine to start.
Connecting Electrical Loads
• Let engine stabilize and warm up for a few minutes after
starting.
• Plug in and turn on the desired 120 and/or 240 VoltAC,
single phase, 60 Hz electrical loads.
• DO NOT connect 240Volt loads to the 120Volt duplex
receptacles.
• DO NOT connect 3-phase loads to the generator.
• DO NOT connect 50 Hz loads to the generator.
• DO NOT OVERLOAIDTFiE GENERATOR. See
"Don't Overload Generator".
CAUTION
See*'Don't Overload Generator".
Start generator and let engine stabilize before connecting
electrical loads.
Connect electrical loads in OFF posidom then turn ON for
operation.
Turn electrical loads OFF and disconnect from generator
before stopping generator:
the Engine
I. Turn OFF and unplug all electrical loads from
generator panel receptacles. NEVER start or stop engine
with electrical devices plugged in and turned ON.
2. Let engine run at no-load for several minutes to
stabilize internal temperatures of engine and generator.
3. Move engine on/off switch to "Off" position.
L O NOT stop engine by moving choke lever to "Choke"
position.
4. Move fuel valve to "Off' position.
G EN ERATOR ADAPTER
CORD SET
The generator is equipped with a 25' generator adapter
cord set designed for a 240Volt, 30 Amp grounded neutral
circuit (Figure 9).
- _ - - _ ® "a,D - • e -
The maximum load on each outlet is 15 Amps,The
maximum total load on both yellow wire outlets or black
wire outlets is 30 Amps. Each outlet is protected by a
15 Amp fuse.
NOTE: Follow all safety precautions when connecting any
extension cord or device to the generator.
O