Airbus CARK91B Guia De Instalacion página 8

Ignition Sense IGNS
The ignition sense feature prevents your car kit from draining the car battery by
executing an auto power off 20 seconds after the ignition key has been turned off. The
blue cable from PCH-4J is used for the ignition sense feature. The use of ignition sense
is recommended to prevent accidental draining of the car's battery. The cable is
EN
connected via a 1-A fuse to a 12- V supply that is controlled by the ignition key. Do not
connect it directly to the high voltage sections of the ignition circuit.
Car Radio Muting CRM
The car kit offers a feature that can mute the car radio automatically during a
conversation. The following is the circuit diagram for CRM.
GND
To XCRM line
(yellow wire)
Another possibility is to use a special muting unit, which mutes the radio by connecting
load resistors to the speaker lines of the car radio.
Antenna Motor Control AMC
The antenna motor control may be used to turn different devices on and off. The
maximum output current is 200 mA; therefore, for example, a motorized antenna must
be controlled via a relay, see diagram below.
Supply
for
device
From AMC line
(green wire)
All installations should take into account any special requirements of the customer.
However, should the customer require an installation that is illegal or unsafe these facts
must be pointed out to the customer and a policy of non-compliance adopted.
6/8
Car Kit CARK91B - Installation Guide
CAR
87A
RADIO
87
85
Relay (12 V)
12 V d.c.
30
86
Fuse 1 A
®
Copyright 2015 - 2017 Airbus DS SLC. All rights reserved.
Relay (12 V)
30
86
Fuse 200 mA
(not supplied)
87A
CONTROLLED
87
DEVICE e.g.
MOTOR ANTENNA
85
08/2017
12 V d.c.
Supply for
car radio
12 V d.c.
GND
GND
IH - PS11727BMLAA01