Trouble Shooting - Dustcontrol DC 1800 H EX Manual Original

Trouble Shooting

Problem
The motor stops directly
after starting.
Fan runs but no suction.
Fan runs but poor suction.
Machine blows dust.
Abnormal sound from
machine.
2016-11-01
Fault
Incorrect fuse.
Overheating protection has
tripped.
Hose not connected.
Hose plugged.
The container is not installed
properly.
Hole in the hose.
Plugged fi lter.
Hose too long or too small.
Hose is kinked.
Machine top is mounted in-
correctly.
Dust is packed in the cyclone.
Filter is perforated or has
come loose.
DC 1800/2800 H EX - 18
Solution
Change to correct circuit.
Investigate why the motor
has overloaded and rectify
the cause. Make sure that
the machine has warmed
up by waiting for 5 minutes.
Restart the motor by fi rst
turning the switch to the "O"
position and then turning it
back to the start position.
Connect the hose.
Remove block.
Install container.
Change or repair hose.
Clean or change fi lter.
Change the hose.
Check and free.
Adjust the mounting.
Take off the top and clean
out.
Check the fi lters and change
if necessary.
Order service.
Part No 94169-F