Shave
Using the shaver
1
1
Rotate the lock ring to
unlock the power switch
and press the power
switch.
Page 4
•
We recommend using the shaver in an ambient temperature
range of 5 ‑ 5 °C. If used outside this range, the appliance may
stop operating.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard. You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
Caution
•
If you press the power switch for more than seconds, the
sonic vibration cleaning mode is activated.
You cannot shave in this mode.
•
Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to turn off or enter the sonic
vibration cleaning mode. Place your fingers on the finger rest
while using the shaver.
6
ES-LF71_EU.indb
6
2
2
Hold the shaver
as illustrated
above and shave.
Page 9
Pivot action selector
Use to select "SOFT" (soft) or "LOCK"
(lock).
You can change the pivot action whether
the shaver is turned on or off.
Using the trimmer
Slide the trimmer handle up. Place
at a right angle to your skin and
move downwards to trim your
sideburns.
Reading lamps when using
While using
•
Approximate amount of battery charge is
displayed as 0 ‑ 100.
•
It will turn off approximately 5 seconds after operating the switch.
When the battery capacity is low
"0" blinks when operating the shaver.
•
You can shave to times after "0" appears. (This will differ
depending on usage.)
•
A full charge will supply enough power for approx. 14 shaves of
minutes each. (This will differ depending on usage.)
2011/03/03
11:44:28