Assembling Floor Stand - PEERLESS SGLS01 Manual De Instalación

M4 x 12 mm (6)
M5 x 12 mm (4)
504-9013
M4 x 25 mm (4)
504-1015
M6 x 30 mm (4)
I.D. 5.6 mm (4)
540-1057
1
Cut adhesive felt (S) into four pieces as shown in figure 1.1 below and affix to bottom of base (E).
1-1
Attach upright (H) to base (E) using three 3/8-16 x 2.5" socket screws (P). Tighten screws using 7/32"
allen wrench (Q).
1-2
Run cords through upright (H) using cord management holes as shown in figure 1.2.
S
P
fig 1.1
Phillips Adapter Bracket Fasteners
M6 x 12 mm (4)
520-1128
520-1027
M6 x 25 mm (4)
520-1208
510-9109
I.D. 8.7 mm (4)
540-1059
H
E
M8 x 16 mm (6)
520-9257
M8 x 25 mm (4)
520-1031
4 of 30 ISSUED: 07-28-06 SHEET #: 202-9156-4 11-20-06
M6 x 20 mm (4)
M5 x 25 mm (4)
520-9402
multi-washer (6)
M8 x 40 mm (4)
520-1136
CORD MANAGEMENT HOLE
H
CORD MANAGEMENT HOLE
fig 1.2
520-9543
580-1036