How To Connect The Tornado 7 To A Wireless Transmitter; How To Disconnect The Tornado 7 From A Wireless Transmitter - Briteq Tornado 7 Manual De Instrucciones

ENGLISH
WIRELESS DMX (OPTIONAL MODULE)
The standard "TORNADO 7" is not equipped with wireless DMX !
If needed you can order an optional wireless DMX module (Wireless Solution
in your projector. Installation of the wireless module will be done by Briteq

HOW TO CONNECT THE TORNADO 7 TO A WIRELESS TRANSMITTER

 First make sure that your projector is equipped with wireless DMX: in such case the projector has a DMX
antenna on the back panel (n°11 in the descriptions)
 In the setup menu choose the following settings:
 Operation Mode: set to "DMX Operation" = Yes ("D" in the upper right corner of the display)
 Config Settings: choose DMX Priority = Wireless Only, Wireless First or Wireless to XLR.
 Check that your Wireless DMX-transmitter is compatible with the "Wireless Solutions" protocol. You can
for example choose the Briteq
 Make sure that the Wireless DMX-transmitter is receiving a valid DMX-signal.
 Press the SETUP-button on the Wireless transmitter: the STATUS-led on the transmitter and the W-DMX
led on the TORNADO 7 will blink fast to indicate that the "pairing" process has started.
 Once the both are connected, the W-DMX led on the TORNADO 7 is lit.
Note: when the wireless signal is lost, the W-DMX led blinks slowly.

HOW TO DISCONNECT THE TORNADO 7 FROM A WIRELESS TRANSMITTER

 In Config Settings: choose "Unlink Wireless" and confirm.
 The W-DMX led turns dark to indicate that no DMX signal is received.
HOW TO TRANSFER A COMPLETE DMX-512 UNIVERS TO THE CONNECTED UNITS
 Connect the unit with wireless DMX-antenna as first unit in the DMX-chain.
 Daisy connect as many DMX-projectors as you like to the XLR-output of the first unit.
 Make sure that the Wireless DMX-signal is received (see above)
 In Config Settings of the first unit: choose "Wireless to XLR" and confirm.
All units in the DMX-chain will receive the complete 512 DMX channels!
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
BRITEQ
®
®
WT-DMXG4 transmitter (order code: 4633).
11/65
USER MANUAL
®
from Sweden) to be installed
®
or its distributor in your country.
TORNADO 7