PROCEDURE
C
D
Redirect the louvers at the back of the wall
sleeve to 60 ° angle as shown in the FIG 8.
The use of pliers is recommended.
7 3/32"
g0o
Rear Louvers
(Top View)
D
Install the new unit into the wall sleeve
O
Assemble trim a described in Step6, Procedure A.
Move to previous page.
FIG. 8
Remove the backing from the 1113/16" shim
strips and attach them as shown below in Fig.
16. The higher portion of shim is to be placed
in front of the rib on the base of wall sleeve.
1
.i h
FIG. 16
FIG. 17
_"_lf
you wish to keep the unit be operated at
higher performance state, remove the steel rear
grille and attach the plastic rear grille. The
plastic rear grille will minimize the recirculation
of hot discharge air.
Plastic rear grille
Steel rear
FIG. 18
-10-