Remote Control; Temperature Setting; Fan Speed - Kenmore 580.74093 Manual Del Propietário

REMOTE CONTROL
NOTE: The Remote Control will not operate properly if strong light shines on the sensor window of the Air
Conditioner or if there are obstacles between the Remote Control and the Air Conditioner.
Evew time you push button, you will hear a beep from the Air Conditioner.
POWER
• To turn the air conditioner ON, push this button. To turn the air
conditioner OFF, push the button again. This button takes priority over
any other button.
When you first turn it on, the unit is in cool mode, High fan speed,
Temperature setting at 72°F.
TEMPERATURE SETTING
• Use this button to automatically control the temperature of the room.
The temperature can be set within a range of 60°F to 86°F by
increments of I°F.
• The setting appears in the display.
FAN SPEED
• Every time you push this button it advances the setting as follows:
(High _Low _Med _High)
TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours until shut-off.
• For your sleeping comfort, once Time is set, the Temperature setting will
raise 2°F after 30 rain, and once again after another 30 rain.
• Push Timer button to advance setting from 1Hour _2Hours _ ...
12Hours maximum.
- START TIME
• If unit is off, Timer sets number of hours before unit starts.
• Push Timer button to advance setting from 1Hour _2Hours _ ...
12Hours maximum.
Fan Speed
MODE
- You push this button to shift mode of operation from COOL _ENERGY SAVER _FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will be turned on so
that the unit can check the room air temperature to determine if cooling is needed.
-14-