Technical Characteristics - Hayward PRHX7010 Manual Del Usuario

INSTALLATION

Technical characteristics

• Point the projector away from the house or
terrace, so as not to create an excessively
bright illumination.
• The projector should not be positioned more
than 30 cm under the coping, as measured from
the centre of the bulb.
• The niche of the projector has a 3/4'' outlet.
• Seal the outlet and the flexible conduit in
accordance with normal working practice at the
connection box.
• 15 W - 12V / Use a safety transformer with an
output greater than or equal to 100 VA at 12V
Liner masonry structure
• Seal the projector wall fitting (ref 3353) into the
masonry, taking the necessary steps to ensure
that you can subsequently apply finishing
rendering around the front panel.
• Screw the flexible conduit onto the niche of the
projector, ensuring that there is a waterproof
seal.
• Screw the entire assembly into the wall fitting,
ensuring that there is a waterproof seal.
• Fit the seal onto the front panel of the niche of
the projector.
• Fit the seal onto the projector's niche flange.
• After installing the liner, secure the sealing
flange.
• Make a cut-out in the liner within the fixed part.
• Thread the projector's lighting unit cable through
the flexible conduit up to the connection box (ref
3495EURO).
• Hold the lighting unit in front of the mounting,
and coil-up the cable; then clip the lighting unit
onto the niche.
• Roll-up the cable and put it in the connection
box and proceed with sealing the connection
box.
Liner panelling structure
• Cut a hole 110 mm wide in the panel.
• Install the projector's niche from within the
basin. Fit the rear nut (ref 3492) in order to
maintain it in position.
• Proceed with sealing the liner, cable and flexible
conduit, and install the projector's lighting unit,
in the same way as for the liner projector.
Masonry structure without liner
• Seal the wall fitting (ref 3352) into the masonry,
taking the necessary measures to ensure that
you can subsequently apply finishing rendering
or tiling around the front panel.
• Screw the projector's niche into the wall fitting.
• Proceed with sealing the liner, cable and flexible
conduit, and install the projector's lighting unit,
in the same way as for the liner projector.
Page 3 of 5
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
30 cm
1B PRHX7010
1V PRHX7009
LED Lights
2 RVB PRHX20LDRVB
2 WHITE PRHX20LDW
2
1V
1B
Rev. A