Greasing Of The Blades - Kamikaze KV 360 Manual De Uso

ELECTRIC PRUNING SHEARS
Check the pruning shear frequently, this will keep tool safe and reliable.
• Do not flush the tools or put it in water, it will cause short circuit or
damage the device.
• Keep ventilation, motor and handle cleaning, always use feather clean the
device. Do not use cleanser flush device, it will rust parts.
• Clean the blade after every use, protect by oil or spray protection.
• After continuous work for 8 hours, please open the trigger cover
protection of the equipment and clean up wood chips and other
impurities.
15.1. SHARPENING
• Sharpening is very important to keep blade in good condition and ensure
long life.
• The tool have attached accessory to sharp blade.
• Always check blade is in good condition before to start work. Of course,
the frequency of sharpening depends on the nature of the sheared wood
(hardness and diameter), pruning rate and sharpening tools (special
abrasive tools are provided). As a result, the blade must be checked
frequently during the initial period of use to determine the appropriate
grinding time (check every 15 minutes and you will quickly calculate)
• Adjust the clearance of the moving blade to ensure that the cut is clean
and accurate. The gap between the blades should be checked regularly
as friction wears the blades where they come into contact. The nut is
designed to block its position with the central screw which allows
adjustments if needed.
• To adjust the blade to the appropriate distance of about 0.03 mm loosen
the central screw of the nut by turning it clockwise, turn the nut clockwise
to reduce the clearance and counterclockwise to increase the clearance.
When the adjustment is complete, hold the nut locked in place and tighten
the central screw by turning it counterclockwise

15.2. GREASING OF THE BLADES

The greasing of the blades has sto be repeated each 2-3 working days to
guarantee the correct performance of the tool and to avoid the seize of
the blades.
77
www.kamikazevolpi.com